SCM Sandya 20 RCS 135 VN two head 52" wide belt sander
Used SCM Sandya 20 RCS 135 VN, 52”, 2-Head Veneer Sander complete with the following:
- 230 volt
- Controller – CN51
- Serial# AE/021515
- First sanding group grooved steel calibrating roller with 250mm (10 in.) diameter
*42 hp @ 60 hz main motor sanding at 18 meters per minute
- Second sanding group combination head with 175mm (7 in.) 45 shore grooved rubber finishing roller and finishing platen
*46 Sector Electronic Sectional Pad and reading bar
*Extractable pad graphite
*24 hp 2 speed 60 hz main motor sanding at 9 and 18 meters per minute
- On/off auto selection of all sanding units from control panel
- Grooved rubber coated pressure roller in first position for increased panel grip with multiple pieces
- Rubber pressing roller in position 3 and 4
- 3 hp variable speed feed unit. Feed speed is from 15 fpm to 70 fpm
- Electronic adjustment of feed from controller
- Automatic conveyor belt tracking
- Infeed and outfeed table extensions with 2 support rollers each
- Extra sturdy robotic welded base with top ground for zero reference point
- Control panel with dust proof membrane keyboard
- Y-Delta two-stage reduced voltage starter on main motor
- Automatic Table Positioning Device
- Electronic digital thickness readout of work table position
- Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
- Accurate and reliable electronic tracking of abrasive belt and air jet cleaning device
- Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive beltAkins
- Front and rear emergency stop buttons
- Automatic trouble shooting panel and emergency stop of machine for: sanding belt breaking, tensioning, over tracking opening of the access door to the operating groups absence of compressed air overload on main motors
- Amperage meter for main motors allows maximum utilization of available horsepower
- Main disconnect switch with the ability to be locked out by padlock
- In feed flexible steel hold down , and anti kick back plate
- 3/8 in. thick 50 shore, negative profile (waffle style) rubber feed mat
- Working Width 53 “
- Number of Heads Available 2
- Motor HP Available:
First Sanding Group 42 hp
Second Sanding Group 24 hp 2 speed
Feed Motor 3 hp
- Maximum Work piece Thickness 6.25 in.
- Minimum Work piece Length 17 inches
- Abrasive Belt Size 53 in. X 103 in.
- Compressed Air Requirements 5 cfm. @ 80 psi.
- Dust Outlets 2 outlets @ 7.7 in.
- Exhaust Requirements 3600 cfm.
- Power Requirements 182 amps @ 230V
© 1957 - 2021 Akins Machinery. All rights reserved.